84067 1/8 TRF801X      This buggy’s highly efficient drive system comes from the optimized placement of the front and rear propeller shafts. The driveline is virtually straight which makes it the most efficient driveline in its class. The TRF801X chassis has plenty of adjustability to fine-tune it for the most demanding of racetracks across the globe. TRF drivers from around the world will be piloting the new competition level Buggy throughout 2010 in an effort to further develop its potential and a new line of TRF801X option parts.   Tamiya drivers had an excellent result in Canada. 2009 was a tremendous race season. TRF driver Abiye Biru showed what his new Tamiya ride could do! Winning his 1st race at the Niagara leg of the GLORCS (Great Lakes RC series)!  Abiye Birku and Gareth Houben went on to finish 2nd & 3rd in the 2009 GLORCS series! Over in the R/C Pro series Steve Bortolotti racked up a 2nd place finish at the Ontario finals at Legacy Hobbies. Making Tamiya cars a favourite on the podium.

-Wheelbase: 320-327mm, Length: 495mm, Width: 307mm. -Gear ratio: 11.34:1 -Features a 15 degree engine mount. The 15 degree engine mount will optimize the weight distribution of the buggy for better lateral weight distribution. -The 801X incorporates two receiver battery locations in order to provide the ability to adjust weight distribution. -Highly rigid 3mm A7075 anodized duralumin chassis. -Machined aluminum shock towers, front steering knuckles, and engine mount. -Full ball bearings. -Chassis side guards. -Low wear, efficient straight line drive train and universal drive shafts. -Carbon fiber upper deck and servo tray. -Fully sealed box for electronics. -Equipped with sealed bevel differential gearboxes. -Uses spiral cut ring and pinion gears. -Uses a universal joint for the front and rear drive shafts and the propeller shaft. -3 piece centrifuge aluminum dampers and shaft bolts. -Locknut captured suspension hinge pins. -15mm large volume shocks with shaft boots. -Uses a 17mm hex wheel hub. -Dual 32mm brakes and a turnbuckle brake linkage system. -Adjustable turnbuckle linkages. -Equipped with front and rear stabilizers. -High volume air filter. -125cc fuel tank. -Low profile polycarbonate body and a high down force wing. -Decorative body stickers. -Engine not included. (Appropriate engine sizes .21 & .28)